經典日本特撮●動畫●卡通回憶

標題: 如何防止合金玩具氧化?? [打印本頁]

作者: Delight986 時間: 30-9-2010 21:14 標題: 如何防止合金玩具氧化??

如何防止合金玩具氧化??

方法有3

1) 把超合金放入已有防潮珠或電子防潮箱中。 (不過又貴, 又唔可以整天拿出來)

2) 到模型店買全光沢或半光沢的叻架，噴在超合金上。 (但超合金變厚了, 可能變得太反光.)
防潮漆: Damp-proof paint Lacquer

3) 這是自聖鬥士超合金推出之後，後多收藏家使用的方法, 又平, 又不失超合金本身的外觀, 這就是抺油.

抺油是用防銹油, 一般是用大家常見的WD-40, 再講求一點, 金錢不是問題, 就可以購買3M的"防潮保護漆"(不是含有97%鋅那種, 也不是黃油).

3M Insulating Paint Spray 電氣絕緣漆1601 1602 1603 1604 14853
It isolates from the mould, is damp-proof and is characterized by its high dielectric rigidity. ... 3M Scotchkote Electrical Coating / 3M 電氣絕緣防水漆 ...
http://www.phi.com.tw/lub1601.htm

3M Scotchkote Electrical Coating / 3M 電氣絕緣防水漆

Scotchkote electrical coating is intended for use as an outer seal on plastic tape applications which are subjected to excessive amounts of oil. It also improves the weather resistance and moisture resistance of the taped joint or splice. It is suitable for direct burial, direct water immersion or above ground applications.

A fast drying sealant and bonding compound, the coating is provided in a brush top 16 oz. can for quick and easy application, can containing 15 fl. oz. (0.44 L) of coating. Case quantity is 10 cans.  Item Number: 14853

* Fast drying / Flexible when dry / self-contained applicator / No waste if container resealed after use. Adhesive to wood, metal, rubber and plastic.

* Compatible with PVC tape. use as an outer seal

* Dielectric Strength : Dry 450Volts/mil  or 24hrs in H2O 200 volts/mil

* Scotchkote can be applied down to approximately 0° F since the flash point of the solvents is 0° F, but the solvents will evaporate more slowly as the temperature decreases. It's operating high temperature is in the 176°F to 194° F ( 90°C) range.

特性: 1.耐候性良好﹐並耐濕氣。2.防止水分滲透﹐保護電機不生銹。3. 具彈性 4.快乾,  在 22 度C 15分鐘後　不黏手.  5. 工作溫度最高為 : 90度C( 190 度F)  閃點: 0°F/-18°C

用途: 1.電動機等之修護時, 作為漆面或絕緣防水之用。2.可增強絕緣能力。3. 室外電路接頭之防水﹑絕緣﹑保護

絕緣效用：乾後 450Volts/mil 或是  24hrs後在水中 200 volts/mil

Copyright © 2010 中央商業有限公司 Power Hub Inc., All Rights Reserved.

把防銹油噴在女士用的化妝綿上 (小毛巾也可, 不過化妝綿非常好用), 噴的份量不多不少, 不言你的超合金就會變得漏油了. 把帶有防銹油的化妝綿印上超合金上就okay 了.

這些防銹油就是聖衣上滑滑的油了.

作者: gt50000 時間: 30-9-2010 21:38

雖然呢個方法可以防止氧化，但會唔會忽略左由於加工以致收藏性大大減低呢？

以我收藏模型超合金玩具，我都唔會除便囉出黎玩或者做display，例如十多年前我入左一盒Popy版V型電池俠boxset，當時盒Boxset係100%新淨 (以當時黎講算難得一見)，買左返黎後真係連一個拳頭都未離開過個發泡膠盒，可能有人會覺得咁玩法好似冇乜趣味，但無辦法因為我要保存佢100%新，所以唯有忍手，耐唔中囉出黎望下就算~

眾多超合金玩具當中其實有少部份係可以囉得出黎玩既我都會好小心，每次玩完都會用布清潔先放番入個盒~

計我話如果相保養玩具既，可以買個膠箱加入防潮珠已經好足夠，但各人有各人既玩法，我只想分享我少少意見~

歡迎光臨經典日本特撮●動畫●卡通回憶 (http://oldcake.net/)